SKU
MBASQ0
Middy® Two-Port Square Base Flashing
DETAILS:
•accommodates:
•one - 0" to 2" pipe (center port)
•one- 3/8" pipe/cable (side port)
•easy installation Middy® two-port square base flashing used on metal roofs where more than one port is...
Read More •accommodates:
•one - 0" to 2" pipe (center port)
•one- 3/8" pipe/cable (side port)
•easy installation Middy® two-port square base flashing used on metal roofs where more than one port is...
DETAILS:
- accommodates:
- one - 0" to 2" pipe (center port)
- one- 3/8" pipe/cable (side port)
- easy installation
MATERIAL SPECIFICATIONS:
TEST TYPE | EPDM | SILICONE |
---|---|---|
Advance ozone resistance test @ 500 pphm | 70 hours | 70 hours |
High Temperature: intermittent- continuous- |
+275ºF +212ºF |
+500ºF +437ºF |
Low Temperature: resistance tested to- tensile strength- |
-65ºF 1,450 psi |
-100ºF 700 psi |
INSTALLATION INSTRUCTIONS:
1. | cut to approximately 20% smaller than the diameter of the penetration |
2. | slide the flashing down the penetration, using water to lubricate if necessary |
3. | form & bend the aluminum base of the flashing to fit the surface of the roof |
4. | seal the flashing by applying urethane/silicone sealant between the flashing & the roof |
5. | use a large slot screwdriver to press the base down tightly |
6. | fasten the flashing with weather-resistant fasteners to complete the seal |
TECHNICAL DATA:
TEST TYPE | EPDM | SILICONE |
---|---|---|
Advance ozone resistance test @ 500 pphm | 70 Hours | 70 Hours |
High Temperature: Intermittent- Continuous- | +275ºF +212ºF | +500ºF +437ºF |
Low Temperature: Resistance tested to- Tensile strength- | -65ºF 1,450 psi | -100ºF 700 psi |
1. | Cut to approximately 20% smaller than the diameter of the penetration. |
2. | Slide the flashing down the penetration, using water to lubricate if necessary. |
3. | Form & bend the aluminum base of the flashing to fit the surface of the roof. |
4. | Seal the flashing by applying urethane/silicone sealant between the flashing & the roof. Use a large slot screwdriver to press the base down tightly. |
5. | Fasten the flashing with weather-resistant fasteners to complete the seal. |